SEN00717-01 40 Troubleshooting Failure code [CA122] Chg Air Press Sensor High Error 1 8 D155AX-6 Action code Failure code Trouble Chg Air Press Sensor High Error (Engine controller system) E03 CA122 Contents of trouble • Signal voltage in charge pressure sensor circuit is abnormally high. Action of controller • Fixes charge pressure (400 kPa {4.08 kg/cm2}) and continues operation. Problem that appears on machine • Acceleration performance of engine lowers or black smoke is produced more during acceleration. Related information • State of charge pressure sensor can be checked with monitoring function. (Code:
36500 Charge Pressure-Abs) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power sup- ply system If code [CA187] or [CA227] is indicated, carry out troubleshooting for it first. 2 Defective charge pressure sensor (Internal trouble) a Prepare with starting switch OFF, then turn starting switch ON or start engine and carry out troubleshooting. PIM Voltage Between (1) – (2) Power supply 4.75 – 5.25 V Pressure sensor voltage is measured with wiring harness con- nected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.
3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC1 (female) (37) – PIM (female) (1) Resis- tance Max. 1 z Wiring harness between EGC1 (female) (47) – PIM (female) (2) Resis- tance Max. 1 z Wiring harness between EGC1 (female) (44) – PIM (female) (3) Resis- tance Max. 1 z 4 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
Wiring harness between EGC1 (female) (37) – PIM (female) (1) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC1 (female) (47) – PIM (female) (2) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC1 (female) (44) – PIM (female) (3) and chassis ground Resis- tance Min. 1 Mz 5 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC1 (female) (37) – PIM (female) (1) and between EGC1 (female) (47) – PIM (female) (2) Resis- tance Min.
1 Mz Wiring harness between EGC1 (female) (37) – PIM (female) (1) and between EGC1 (female) (44) – PIM (female) (3) Resis- tance Min. 1 Mz Chassis ground between EGC1 (female) (47) – PIM (female) (2) and between EGC1 (female) (44) – PIM (female) (3) Resis- tance Min. 1 Mz 6 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON or start engine and carry out troubleshooting. EGC1 Voltage Between (37) – (47) Power supply 4.75 – 5.25 V