SEN00717-01 40 Troubleshooting Failure code [CA131] Throttle Sensor High Error 1 12 D155AX-6 Action code Failure code Trouble Throttle Sensor High Error (Engine controller system) E03 CA131 Contents of trouble • Signal voltage in decelerator pedal potentiometer circuit is abnormally high. Action of controller • Sets throttle position with fuel control dial signal and continues operation. Problem that appears on machine Related information • State of decelerator pedal optimum operation range signal can be checked with monitoring function. (Code:
03001 Throttle Pos Sens Volt) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power sup- ply system If code [CA2185] or [CA2186] is indicated, carry out troubleshoot- ing for it first. 2 Defective fuel control dial (Internal trouble) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
DCL (male) Resistance Between (B) – (C) 1.5 – 2.5 kz Between (A) – (B) 0 – 3 kz Between (A) – (C) 0 – 3 kz 3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC2 (female) (9) – DCL (female) (A) Resis- tance Max. 1 z Wiring harness between EGC2 (female) (22) – DCL (female) (B) Resis- tance Max. 1 z Wiring harness between EGC2 (female) (23) – DCL (female) (C) Resis- tance Max.
1 z 4 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC2 (female) (9) – DCL (female) (A) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC2 (female) (22) – DCL (female) (B) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC2 (female) (23) – DCL (female) (C) and chassis ground Resis- tance Min. 1 Mz 5 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.
EGC2 Voltage Between (22) – (23) Power supply 4.75 – 5.25 V Between (9) – (23) Signal 0.5 – 4.5 V