SEN00717-01 40 Troubleshooting Failure code [CA135] Eng Oil Press Sensor High Error 1 16 D155AX-6 Action code Failure code Trouble Eng Oil Press Sensor High Error (Engine controller system) E02 CA135 Contents of trouble • Signal voltage in engine oil pressure sensor circuit is abnormally high. Action of controller • Sets engine oil pressure to default value (250 kPa {2.55 kg/cm2}) and continues operation. Problem that appears on machine Related information • State of engine oil pressure sensor can be checked with monitoring function. (Code:
37201 Eng Oil Press Sens Volt) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power sup- ply system If code [CA187] or [CA227] is indicated, carry out troubleshooting for it first. 2 Defective engine oil pressure sensor (Internal trouble) a Prepare with starting switch OFF, then turn starting switch ON or start engine and carry out troubleshooting. POIL Voltage Between (1) – (2) Power supply 4.75 –5.25 V Sensor voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and con- troller, too, for another cause of trouble, and then judge.
3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC1 (female) (37) – POIL (female) (1) Resis- tance Max. 1 z Wiring harness between EGC1 (female) (47) – POIL (female) (2) Resis- tance Max. 1 z Wiring harness between EGC1 (female) (13) – POIL (female) (3) Resis- tance Max. 1 z 4 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
Wiring harness between EGC1 (female) (37) – POIL (female) (1) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC1 (female) (47) – POIL (female) (2) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC1 (female) (13) – POIL (female) (3) and chassis ground Resis- tance Min. 1 Mz 5 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC1 (female) (37) – POIL (female) (1) and between EGC1 (female) (47) – POIL (female) (2) Resis- tance Min.
1 Mz Wiring harness between EGC1 (female) (37) – POIL (female) (1) and between EGC1 (female) (13) – POIL (female) (3) Resis- tance Min. 1 Mz Wiring harness between EGC1 (female) (47) – POIL (female) (2) and between EGC1 (female) (13) – POIL (female) (3) Resis- tance Min. 1 Mz 6 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON or start engine and carry out troubleshooting. EGC1 Voltage Between (37) – (47) Power supply 4.75 – 5.25 V