SEN00718-01 40 Troubleshooting Failure code [CA2185] Throt Sens Sup Volt High Error 1 24 D155AX-6 Action code Failure code Trouble Throt Sens Sup Volt High Error (Engine controller system) E03 CA2185 Contents of trouble • Signal voltage in throttle sensor power supply (5 V) circuit is abnormally high. Action of controller • Sets throttle position with signal of fuel control dial and continues operation.
Problem that appears on machine Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuel control dial (Internal trouble) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Disconnect devices at right in order. If "E" of failure code disappears when a device is discon- nected, that device has trouble in it. Decelerator pedal potentiometer DCL connector 2 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
Wiring harness between EGC2 (female) (22) – DCL (female) (B) Resis- tance Max. 1 z Wiring harness between EGC2 (female) (23) – DCL (female) (C) Resis- tance Max. 1 z 3 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC2 (female) (22) – DCL (female) (B) and chassis ground Resis- tance Min. 1 Mz Wiring harness between EGC2 (female) (23) – DCL (female) (C) and chassis ground Resis- tance Min.
1 Mz 4 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between EGC2 (female) (22) – DCL (female) (B) and between EGC2 (female) (23) – DCL (female) (C) Resis- tance Min. 1 Mz 5 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. EGC2 Voltage Between (22) – (23) 4.75 – 5.25 V