Komatsu D155AX-6 — FAILURE CODE [DDDDKA] BACK UP BRAKE SW: DISCONNECTION

SEN00719-01 40 Troubleshooting Failure code [DDDDKA] Back up brake Sw: Disconnection 1 34 D155AX-6 Action code Failure code Trouble Back up brake Sw: Disconnection (Power train controller system) E02 DDDDKA Contents of trouble • Signals of 2 systems of brake pedal switch circuit are turned OFF (opened) simultaneously. Action of controller • Recognizes that brake pedal is not pressed. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.

Related information • "NO" signal of 2 systems of switch is for sensing operation and "NC" signal is for detecting error. • State of brake pedal switch signal can be checked with monitoring function. (Code: 40905 T/M Sw Input1) • Method of reproducing failure code: Turn starting switch ON + Operate brake pedal. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse (FS2-1) If fuse is broken, circuit probably has ground fault (See cause 4). 2 Defective brake pedal switch (Internal disconnection) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.

BKSW (male) Brake pedal Released Pressed Resistance between (A) – (B) Max. 1 z Min. 1 Mz Resistance between (A) – (C) Min. 1 Mz Max. 1 z 3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between FS22 (1) – BKSW (female) (A) Resis- tance Max. 1 z Wiring harness between STC1 (female) (11) – BKSW (female) (B) Resis- tance Max. 1 z Wiring harness between STC1 (female) (5) – BKSW (female) (C) Resis- tance Max.

1 z 4 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between FS22 (1) – BKSW (female) (A) and chassis ground Resis- tance Min. 1 Mz Wiring harness between STC1 (female) (11) – BKSW (female) (B) and chassis ground Resis- tance Min. 1 Mz Wiring harness between STC1 (female) (5) – BKSW (female) (C), PBS (female) (1) or PBD (female) (1) and chassis ground Resis- tance Min. 1 Mz 5 Defective power train con- troller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

STC1 Brake pedal Released Pressed Voltage between (11) – chassis ground 20 – 30 V Max. 1 V Voltage between (5) – chassis ground Max. 1 V 20 – 30 V