Komatsu D155AX-6 — FAILURE CODE [DK31KA] ST LEVER 2: DISCONNECTION

SEN00721-01 40 Troubleshooting Failure code [DK31KA] ST lever 2: Disconnection 1 10 D155AX-6 Action code Failure code Trouble ST lever 2: Disconnection (Power train controller system) E03 DK31KA Contents of trouble • Signal voltage of PCCS lever steering potentiometer 2 system is below 0.5 V. Action of controller • Continues control with signal of PCCS lever steering potentiometer 1 system. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.

Related information • State of PCCS lever steering potentiometer 2 signal can be checked with monitoring function. (Code: 50301 S/T Lever 2 Potentio) • Method of reproducing failure code: Turn starting switch ON + Operate PCCS lever (in steering direction). Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor 5V power supply system If failure code [DBE7KK] is also displayed, carry out troubleshoot- ing for it first. 2 Defective PCCS lever steer- ing potentiometer 2 (Internal disconnection) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.

TLV1 (male) PCCS lever Resistance Between (5) – (8) Neutral 3.2 kz ± 20% Between (5) – (6) 1.6 kz ± 20% Between (6) – (8) 1.6 kz ± 20% 3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC1 (female) (22) – TLV1 (female) (5) Resis- tance Max. 1 z Wiring harness between STC1 (female) (19) – TLV1 (female) (6) Resis- tance Max. 1 z 4 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.

Wiring harness between STC1 (female) (19) – TLV1 (female) (6) and chassis ground Resis- tance Min. 1 Mz 5 Defective power train con- troller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. STC1 Voltage Between (19) – (21) 0.5 – 4.5 V