SEN00721-01 40 Troubleshooting Failure code [DWN1KA] Hss EPC1: Disconnection 1 Circuit diagram related to HSS left EPC solenoid 36 D155AX-6 Action code Failure code Trouble ( Hss EPC1: Disconnection Power train controller system) E03 DWN1KA Contents of trouble • When signal is output to HSS left EPC solenoid circuit, no current flows. Action of controller • Turns signal to HSS left EPC solenoid circuit OFF. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1.
Related information • Output to HSS left EPC solenoid can be checked with monitoring function. (Code: 50600 HSS Solenoid LH (F/B)) • Method of reproducing failure code:
Turn starting switch ON + Operate PCCS lever (Left steering) Possible cause and standard value in norm state Cause Defective HSS left EPC sole- 1 noid (Internal disconnection) Disconnection in wiring har- ness (Disconnection in wiring s 2 or defective contact in con- nector) al Hot short (Short circuit with 3 24V circuit) in wiring harness I Defective power train con- 4 troller Standard value in normal state/Remarks on troubleshooting a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
HSL (male) Resistance Between (1) – (2) 4.5 – 14.5 z a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (25) – HSL (female) (1) Resis- tance Max. 1 z Wiring harness between STC3 (female) (3) – HSL (female) (2) Resis- tance Max. 1 z a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between STC3 (female) (3) – HSL (female) (2) or circuit branch end and chassis ground Voltage Max. 1 V f causes 1 – 3 are not detected, power train controller may be defective. (Since trouble is in system, troubleshooting cannot be carried out.)