40 Troubleshooting SEN00722-01 Failure code [DXHYKB] Ripper Tilt In EPC: Short circuit 1 Circuit diagram related to ripper tilt-in EPC solenoid D155AX-6 49 Action cod e Failure code Trouble Ripper Tilt In EPC: Short circuit (Work equipment controller system) E03 DXHYKB Contents o trouble f • When signal was output to ripper tilt-in EPC solenoid circuit, abnormal current flowed. Action of controller • Turns signal to ripper tilt-in EPC solenoid circuit OFF. • Limits operation of engine and transmission. Problem th appears o machine at • Ripper cannot be tilted in. n • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to R1.
Related informatio • Output to ripper tilt-in EPC solenoid can be checked with monitoring function. (Code: 71105 Ripper Tilt In EPC (F/B)) n • Method of reproducing failure code: Turn starting switch ON + Operate ripper control lever (Tilt in). Possible cau and standa value in nor state Cause Defective ripper tilt-in EPC 1 solenoid (Internal short cir- cuit) ses rd Ground fault in wiring har- mal 2 ness (Contact with GND cir- cuit) Defective work equipment 3 controller Standard value in normal state/Remarks on troubleshooting a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
WEP9 (male) Resistance Between (1) – (2) 2 – 12 z Between (1) – chassis ground Min. 1 Mz a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between WEC3 (female) (25) – WEP9 (female) (1) and chassis ground Resis- Min tance . 1 Mz a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. WEC3 (female) Resistance Between (25) – (23) 2 – 12 z Between (25) – chassis ground Min. 1 Mz