SEN00723-01 40 Troubleshooting Failure code [DXJ8KY] Blade left 2 EPC: Short circuit 1 Circuit diagram related to blade tilt left bottom EPC solenoid 4 D155AX-6 Action code Failure code Trouble Blade left 2 EPC: Short circuit (Work equipment controller system) E03 DXJ8KY Contents o trouble f • When signal was output to blade tilt left bottom EPC solenoid circuit, abnormal current flowed. Action of controller • Turns signal to blade tilt left bottom EPC solenoid circuit OFF. • Limits operation of engine and transmission. Problem tha appears on machine t • Blade tilt cylinder or pitch left cylinder cannot be extended. • Once machine is stopped, engine speed is limited to medium (half).
• Once machine is stopped, travel is limited to R1. Related information • Output to blade tilt left bottom EPC solenoid can be checked with monitoring function. (Code: 71007 Blade Tilt LH-B EPC (F/B)) • Method of reproducing failure code: Turn starting switch ON + Operate blade control lever (Pitch forward).
Possible caus and standar value in norm state Cause Defective blade tilt left bot- 1 tom EPC solenoid (Internal short circuit) es d Hot short (Short circuit with al 2 24V circuit) in wiring harness Defective work equipment 3 controller Standard value in normal state/Remarks on troubleshooting a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. WEP4 (male) Resistance Between (1) – (2) 2 – 12 z Between (1) – chassis ground Min. 1 Mz a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between WEC3 (female) (38) – WEP4 (female) (1) and chassis ground Voltage M ax.
1 V a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. WEC3 (female) Resistance Between (38) – (13) 2 – 12 z Between (38) – chassis ground Min. 1 Mz