Komatsu D155AX-6 — TORQUE CONVERTER, PTO

10 Structure, function and maintenance standard SEN00604-00 Outline Structure q The torque converter is a 3-element, 1-stage, and 1-phase type, which is integral with the transmission. q Pump (15) is integrated with coupling (6), input shaft (7), lockup clutch housing (10), and drive case (12), and rotated by the engine power. q The torque converter is equipped with a wet double disc clutch type torque converter lockup device and a stator clutch in order to reduce fuel consumption, to increase the operability, and to reduce the horsepower consumption by the engine. q Turbine (11) is integrated with turbine boss (29) and transmission input shaft (25), and rotated by the oil from pump (15).

q Stator (14) is integrated with stator shaft (20) and stator clutch hub (21), and fixed to torque converter case (5) through the stator clutch unit. q For higher efficiency of continuous light dozing and leveling operation, the torque converter is locked up and the engine power is transferred directly to the transmissions input shaft. q The lockup clutch unit consists of clutch plate (26) meshed with drive case (12), clutch disc (27) meshed with turbine boss (29), and clutch piston (28) which slides inside clutch housing (10) integrated with drive case (12).

q When the torque converter is locked up (the pump and turbine is integrated into 1 unit), the oil is still supplied to the torque converter. q The stator clutch unit consists of clutch hub (21) attached to stator shaft (20) with spline, clutch disc (23) meshed with clutch hub (21), clutch plate (22) supported by the pins on clutch front housing (17) and clutch rear hous- ing (19), and clutch piston (24) which slides inside clutch front housing (17). Accordingly, the oil flowing from the pump through the turbine to the stator is obstructed by the stator blades and cannot flow in any direction. As a result, this oil resists the rotation of the pump and turbine (it is agitated).

q To reduce the rotating resistance of the pump and turbine, the stator clutch is disengaged simultaneously with lockup of the torque con- verter so that the stator can rotate freely. Clutch front housing (17) is fixed to sleeve (35) with torque converter case (5). q The PTO unit consists of input shaft (7), PTO idler gear (8), PTO gear A(30), PTO gear B(31) and scavenging pump drive gear (32). As the stator is dragged and turned by the pump and turbine, the oil returns from the tur- bine to the pump smoothly against less resis- tance. Conditions for lockup range and torque con- verter range Torque converter output shaft speed D155AX-6 13 Lockup range Torque converter range Forward 1st Min.

1,313 rpm Max. 1,262 rpm Forward 2nd Min. 1,899 rpm Max. 1,876 rpm Forward 3rd Min. 1,366 rpm Max. 1,355rpm Reverse 1st Min. 1,244 rpm Max. 1,216 rpm Reverse 2nd Min. 1,196 rpm Max. 1,177 rpm Reverse 3rd Min. 1,622 rpm Max. 1,613 rpm