SEN00807-01 40 Troubleshooting E-3 Engine does not start (Engine does not turn) 1 12 D155AX-6 Trouble • Engine does not start (Engine does not turn). Related information • Engine starting circuit has following 2 start lock mechanisms. 1) Start lock with password of machine monitor 2) Start lock with parking brake lever and work equipment lock lever Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Low charge level of battery a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Battery voltage (2 pieces) Electrolyte specific gravity (1 piece) Min. 24 V Min.
1.26 2 Defective starting switch (Internal disconnection) a Prepare with starting switch OFF, then keep starting switch OFF and turn it to START and carry out troubleshooting in each case. Starting switch Resistance Between 250 – 280 OFF Min. 1 Mz START Max. 1 z 3 Defective neutral safety relay (Internal trouble) a Prepare with starting switch OFF, then turn starting switch to START and carry out troubleshooting. Replace neutral safety relay (Right No.) with another relay. If engine starts at this time, neutral safety relay is defective. NSF 4 Defective starting motor (Internal defect) a Prepare with starting switch OFF, then turn starting switch to START and carry out troubleshooting.
Starting motor Voltage Between B – chassis ground Battery power supply 20 –30 V Between ST (2) – chassis ground Starting signal 20 –30 V Between ST (2) – chassis ground Generation signal Max. 1 V If battery power supply, starting signal, and generation signal are normal but starting motor does not turn, starting motor is defective. 5 Defective alternator (Internal short circuit) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Alternator Voltage Between R – chassis ground Generation signal Max.
1 V 6 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between terminal 280 – NSF (female) (3) Resis- tance Max. 1 z Wiring harness between NSF (female) (5) – PRE – ST (female) (1) Resis- tance Max. 1 z 7 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between terminal 280 – NSF (female) (3) or circuit branch end and chas- sis ground Resis- tance Min.
1 Mz Wiring harness between NSF (female) (5) – PRE – ST (female) (1) and chassis ground Resis- tance Min. 1 Mz 8 Hot short (Short circuit with 24V circuit) in wiring harness a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between terminal R – ST (female) (2) or circuit branch end and chas- sis ground Voltage Max. 1 V