10 Structure, function and maintenance standard SEN00604-00 Unit: mm D155AX-6 15 No.
Check item Criteria Remedy 1 Outer diameter of oil seal contact surface of the coupling Standard size Tolerance Repair limit Repair by hard chrome plating or replace 100 -0.054 -0.054 99.8 2 Inner diameter of the seal ring contact surface of the input shaft 35 +0.025 +0.025 35.1 Wear of the trans- mission input shaft seal ring Width 2.56 -0.01 -0.03 2.3 Replace Thickness 1.7 ±0.1 1.55 3 Inner diameter of the seal ring contact surface of the stator shaft 65 +0.030 +0.025 65.1 Repair by hard chrome plating or replace Wear of the trans- mission input shaft seal ring Width 3 -0.01 -0.03 2.7 Replace Thickness 2.7 ±0.1 2.55 4 Inner diameter of the seal ring contact surface of the sleeve 90 +0.035 +0.025 90.1 Repair by hard chrome plating or replace Wear of the stator shaft seal ring Width 3 -0.01 -0.03 2.7 Replace Thickness 3.7 ±0.12 3.55 5 Inner diameter of the seal ring contact surface of the retainer 150 +0.040 +0.025 150.5 Repair by hard chrome plating or replace 6 Backlash between the input shaft and the PTO idler gear 0.198 – 0.484 Replace 7 Backlash between the PTO idler gear and PTO gear A 0.198 – 0.484 8 Backlash between the PTO idler gear and PTO gear B 0.198 – 0.484 9 Backlash between the input shaft and the scavenging pump drive gear 0.198 – 0.484 10 Thickness of the lockup clutch disc 5.0 ±0.1 4.5 Thickness of the lockup clutch plate 5.0 ±0.1 4.5 Overall thickness of the lockup clutch assembly 15.0 ±0.17 13.9 11 Thickness of the stator clutch disc 5.0 ±0.1 4.5 Thickness of the stator clutch plate 5.0 ±0.1 4.5 Overall thickness of the stator clutch assembly 15.0 ±0.17 13.9