40 Troubleshooting SEN00807-01 E-8 Fuel level gauge does not indicate normally 1 Circuit diagram related to fuel level sensor D155AX-6 23 Trouble (1) While fuel is added, fuel level gauge does not rise from red range (E). (2) While fuel level is low, fuel level gauge does not lower from green range top (F) Related nformation • Signal voltage of fuel level sensor can be checked with monitoring function. (Code:
04200 Fuel Level Sensor Volt) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting D 1 (I s efective fuel level sensor nternal disconnection or hort circuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. FLV (male) Fuel level Resistance Between (1) – (2) FULL Approx. 4 z EMPTY Approx. 85 z D n 2 or n isconnection in wiring har- ess (Disconnection in wiring defective contact in con- ector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between CM01 (female) (9) – FLV (female) (1) Resis- tance Max.
1 z Wiring harness between CM01 (female) (12) – FLV (female) (2) Resis- tance Max. 1 z G 3 n c round fault in wiring har- ess (Contact with GND cir- uit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between CM01 (female) (9) – FLV (female) (1) and chassis ground Resis- tance Min. 1 Mz H 4 2 ot short (Short circuit with 4V circuit) in wiring harness a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between CM01 (female) (9) – FLV (female) (1) and chassis ground Voltage Max.
1 V 5 D efective machine monitor If causes 1 – 4 are not detected, machine monitor may be defec- tive. (Since trouble is in system, troubleshooting cannot be carried out.)