Komatsu — SEAT BELT

OPERATION Recognition areas are also shown in the table for reference. Mirror A: Must be able to see hatched area (A) Mirror B: Must be able to see hatched area (B) Mirror C: Must be able to see hatched area (C) Mirror D: Must be able to see hatched area (D) X: 2220 mm (87.5 in) Y: 2650 mm (104.4 in) H: 1600 mm (63.0 in) W: 1000 mm (39.4 in) L: 120 mm (4.7 in) M: 40 mm (1.6 in) SEAT BELT Before fitting the seat belt, check to be sure there is no abnormality in the belt or its mounting bracket. If it is worn or damaged, replace the seat belt. Even if the seat belt appears normal, replace it every 3 years. The date of manufacture of the belt is shown on the back of the belt.

Always wear the seat belt during operations. Fit the seat belt so that it is not twisted. FASTENING AND REMOVING SEAT BELT This seat belt has a retractor, so it is not necessary to adjust the length. Fastening seat belt Hold grip (2) and pull the belt out from the retractor (1), check to be sure the belt is not twisted, then insert tongue (3) into buckle (4) securely. Pull the belt lightly to check to be sure it is properly locked. Removing belt Press button (5) in buckle (4), and remove tongue (3) from the buckle (4). The belt is automatically spooled, hold grip (2) and return the belt slowly to the retractor (1). 2-82 PC300LC/HD-7E0