OPERATION PARKING MACHINE CLEARING THE MACHINES TRACKS If the machine has been operating in extremely muddy areas especially during the colder seasons you may want to perform this procedure before parking the machine for the night. Performing idle-running of the tracks is dangerous, stay well away from the tracks. To prevent mud, water, or the undercarriage from freezing and making it impossible for the machine to move on the fol- lowing morning, observe the following precautions. Remove all the mud and water from the machine body.
In particular, wipe the hydraulic cylinder rods clean to prevent damage to the seal caused by mud, dirt, or drops of water on the rod from getting inside the seal. Park the machine on hard, dry ground. If this is impossible, park the machine on boards. The boards prevent the tracks from freezing to the ground, and allow the machine to be moved the next morning. Open the drain valve and drain any water collected in the fuel system to prevent it from freezing. Fill the fuel tank to capacity. This minimizes moisture condensation in the tank when the temperature drops. After operation in water or mud, remove water from undercarriage as described below to extend undercarriage service life. 1.
Swing 90 o with engine at low idle and bring the work equipment to the side of the track. 2. Jack up the machine until the track is raised slightly from the ground. Rotate the track under no load. Repeat this procedure on both the left and right sides. PARKING Avoid stopping suddenly. Give yourself ample room when stopping. When stopping the machine, select flat hard ground and avoid dangerous places. If it is unavoidably necessary to park the machine on a slope, insert blocks underneath the track shoes. As an additional safety measure, thrust the bucket into the ground. If the control lever is touched by accident, the machine may move suddenly, and this may lead to a serious accident.
Before leaving the operator's compartment, always set the lock lever (3) securely to LOCK position. 1. Put left and right travel levers (1) in the neutral position. 2-106 PC300LC/HD-7E0