WORKING CLEARANCES OPERATION It is always a good idea to be aware of your clearances around, in front, behind and especially above your work area or travel rout. When working or traveling in an area where clearances are a problem, travel at a slow cautious speed. Some basic safety precautions to prevent risk are: If you are not sure of your clearances, request the aid of another person who can guide or warn you if you get too close to objects. Be aware of the dangers when working around overhead electrical lines, high humidity may pose an electrical hazard even if your machine clears the overhead power lines.
If your machine should come in contact with overhead electrical lines, stop the machine and remain on the machine until the power company clears the lines and it is safe to get off or move the machine. If low power lines pose a greater hazard, ask the power company to remove the lines until your work is finished. OPERATIONS ON SLOPES When working on slopes, there is a danger that the machine may lose its balance and roll over when the swing or work equipment is operated. This may lead to serious injury or property damage, always provide a stable place when carrying out these type of operations, and work care- fully.
Do not swing the work equipment from the uphill side to the downhill side when the bucket is loaded. This operation is dangerous, and may cause the machine to tip over. If the machine has to be used on a slope, pile the soil to make a platform that will keep the machine as horizontal as possible. PC300LC/HD-7E0 2-113 Cable Voltage Min. Safe Distance 100 V - 200 V Over 2 m (7 ft) 6,600 V Over 2 m (7 ft) 22,000 V Over 3 m (10 ft) 66,000 V Over 4 m (14 ft) 154,000 V Over 5 m (17 ft) 187,000 V Over 6 m (20 ft) 275,000 V Over 7 m (23 ft) 500,000 V Over 11 m (36 ft)