OPERATION ELECTRONIC CONTROL SYSTEM If an error code appears on the machine monitor display (normally displays TIME), follow the countermeasure table as shown below in the self-diagnosis. MACHINE MONITOR TROUBLE DISPLAY ( ): For details of handling the emergency pump drive switch, swing holding brake cancel switch, and emergency work equipment actuation switch, see “CONSOLE CONTROL SWITCHES” on page 2-33 .
PC300LC/HD-7E0 2-143 Problem Exhaust gas occasionally turns black Main causes ● Clogged air cleaner element ● Defective nozzle ● Defective compression ● Defective turbocharger Remedy ● Clean or replace, see “WHEN REQUIRED” on page 3-20 ● (Replace nozzle) ● (See defective compression above) ● Clean or replace turbocharger Combustion noise occasionally make breathing sound ● Defective nozzle ● (Replace nozzle) Abnormal noise generated (combustion or mechanical) ● Low-grade fuel being used ● Overheating ● Damage inside muffler ● Excessive valve clearance ● Change to specified fuel ● Refer to Radiator water level monitor lights up as above ● Replace muffler ● (Adjust clearance) Monitor display Error mode Countermeasure E02 Pump control system error When emergency pump drive switch is at the up (emergency) position, normal opera- tions become possible, but have inspection carried out immediately.
(★) E03 Swing brake system error Turn the swing prolix switch ON to cancel the brake. When applying the swing brake, operate the swing lock switch manually. Depending on the cause of the failure, it may be impossible to release the brake.In any case, have the system inspected immediately by your Komatsu distributor.(★) E10 Engine controller power source error Engine controller drive system circuit error (engine stooped) Have inspection carried out immediately. E11 Engine controller system error (output reduced to protect engine) Operate machine to a safe posture and have inspection carried out immediately.
E14 Abnormally in throttle system Operate machine to a safe posture and have inspection carried out immediately. E15 Engine sensor (coolant temperature, fuel pressure, oil pressure) error Operations are possible, but have inspection carried out immediately. E0E Network error. Operata machine to a safe posture and have inspection carried out immediately In the case where the monitor will not display error codes and work equipment operation and swing operation cannot be carried out. Have the machine inspected immediately by your Komatsu distributor.