Komatsu — STARTING MACHINE

OPERATION LONG TERM STORAGE BEFORE STORAGE Remark When storing the machine, set the machine in the posture shown in the diagram on the right to protect the cylinder rod. (To prevent rusting of the cylinder rod) When putting the machine in storage for a long time, do as follows. 1. Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select level ground and cover the machine with a sheet. 2. Completely fill the fuel tank, lubricate and change the oil before storage. 3. Apply a thin coat of grease to the metal surface of the hydraulic piston rods. 4.

Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it separately. 5. If the ambient temperature is expected to drop below 0єC (32єF), add antifreeze to the cooling water. 6. Lock each control lever and pedal with the lock lever and pedal lock. 7. Set the stop valve to the LOCK position on machines which can install attachments. Install a plug in the elbow. 8. Set the selector valve on the machines which can install attachments to the “Where no attachment is mounted” position.

DURING STORAGE If it is unavoidably necessary to carry out the rust-preventive operation while the machine is indoors, open the doors and windows to improve ventilation to prevent gas poisoning. During storage, always operate the machine once a month so that a new film of oil will be coated over movable parts and com- ponent surfaces. At the same time, charge the battery. For machines equipped with an air conditioner, run the air conditioner. Rotate the tracks. AFTER STORAGE Remark If the machine is to be used when the monthly rust prevention operation has not been carried out, please con- tact your Komatsu distributor.

When using the machine after long-term storage, do as follows before using it. 1. Wipe off all the grease coating the hydraulic cylinder rods. 2. Add oil and grease to all places. 3. When the machine has been stored for a long time, the moisture in the atmosphere will get into the oil. Check the oil at all parts before and after starting the engine. If there is water in the oil, change all the oil. STARTING MACHINE When starting the engine after long-term storage, cancel the automatic warming-up operation as follows. 1. Turn the ignition switch key to the ON position. 2.

Turn the fuel control dial from the low idling (MIN) position to the full (MAX) position, hold it there for 3 seconds, then return it to the low idling (MIN) position and start the engine. PC300LC/HD-7E0 2-145