REPLACE BUCKET TEETH (VERTICAL PIN TYPE) MAINTENANCE Replace the point before the adapter starts to wear. It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. If the locking pin is knocked out with excessive force, there is a danger that the pin may fly out. Check to be sure there is no one in the surrounding area. Pieces will often fly during the replacement operation, so always wear safety glasses, gloves, and other protective equipment. 1.
To make it possible to knock out the pin of tooth (1), set the bot- tom surface of the bucket on a block, check to be sure the work equipment is in a stable condition, then 2. Set the safety lock lever to the LOCK position. Set so that the bottom face of the bucket is horizontal. 3. Use a hammer and drift to knock out lock pin (2). (If the drift is set against rubber pin lock (3) when it is hit, the rubber pin lock may break. Set it against the back of the pin.) 4. After removing lock pin (2) and rubber pin lock (3), check them. PC300LC/HD-7E0 3-31