MAINTENANCE CLEANING CAB FLOOR When setting the machine at an angle, use strong blocks to stabilize the machine and be extremely careful when doing this. If the control levers are touched by mistake, the work equipment or machine may suddenly move, and this may lead to a serious accident. Set the safety lock lever securely to the LOCK position before getting up from the operator's seat. When cleaning the floor, be careful not to get water on the monitor and connectors inside the operator's cab. Never spray water above the pedestal of the operator's seat (2). With the washable floor, it is possible to flush out the dirt on the cab floor directly with water. Washing 1.
Set the machine at an angle. 2. Swing the upper structure slowly so that the water drain holes (3) in the cab floor are at a low position. 3. Lower the work equipment to the ground and set the machine in a stable condition. PC300LC/HD-7E0 3-39