7. Run the engine at idling for a short time, then stop the engine and check again that the oil level is between the (H) and (L) marks on dipstick (G). 8. Install cover (1). MAINTENANCE CLEAN/INSPECT RADIATOR, OIL COOLER, AFTERCOOLER AND CONDENSER FINS If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. Remark When using compressed air for cleaning, blow it keeping some distance to avoid damaging the fins. Damage on the fins can cause water leakage and overheating.
In a dusty job site, check the fins every day, regardless of the maintenance interval. 1. Open the engine hood. 2. Loosen screw (1) and pull up net (2). 3. Clean net (2). (it is to be installed again, as instructed in the step 8.) 4. Remove 6 bolts (3), then move bracket (4) to the side and make a gap between radiator fins (5) and oil cooler fins (6). 5. Inspect the front and rear of radiator fins (5), oil cooler fins (6), after-cooler fins (7) and condenser fins (8) for dirt, dust, dry leaves, etc. Blow them away with compressed air, if any. Steam or water may be used instead of compressed air. PC300LC/HD-7E0 3-57