Komatsu — CHANGE OIL IN FINAL DRIVE CASE

MAINTENANCE EVERY 2000 HOURS MAINTENANCE Maintenance for every 250, 500 and 1000 hours service should be performed at the same time. CHANGE OIL IN FINAL DRIVE CASE If there is pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. The oil is hot after the engine is stopped. Wait for the temperature to cool before starting the operation. Refill capacity (each): 8.5 liters (2.25 US gal) Flex handle wrench and socket. 1. Set the final drive so that the TOP mark comes to the top and the mark and plug (P) are perpendicular to the ground. 2. Set a container under plug (P) to catch the oil. 3.

Remove plugs (P) and (F) with the wrench and drain the oil. Remark Check the O-rings in the plugs for damage. If necessary, replace with new ones. 4. Tighten plug (P). 5. Add engine oil through the plug hole (F). 6. When the oil overflows from the plug hole (F), install plug (F). Plugs (P) and (F) are tightened to the torque of 68.6 ± 9.8 N•m (50.6 ± 7.2 lbf). Remark There are two plugs (F). Add oil through the one easier to fill oil and through which no internal gears are seen. 3-68 PC300LC/HD-7E0