. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE then run for another 5 4 - 32 3. Turn rad iator cap (2) slowly to remov 4. Open dr ain valve (3 ) at the bottom o valve (4) of the oil co oler and drain th 5. After dra ining the wa ter, close drain v alves (3) and (4), and with city water. 6. When th e radiator is full, start the engi ne, and run it at low id Keep th e engine run ning at low idle for 10 minut coolant t emperature reaches more th an 90°C (194 7. Stop the engine, op en drain valves ( water. A fter draining the water, close 8. Replace the corrosio n resistor, then t urn valve (1) t o open it . ON RESISTOR CARTRID water filler.
For repl acing corrosi on resistor, see " REPLACE C ORROSI 9. Add coo lant mixed w ith antifreeze un til it overflows from the Decide t he proportio ns of antifreeze a nd water according to t he table for the mixing rate 10. To remo ve the air c ontained in the c oolant, run th e engin e at low idle for 5 minutes p OFF.) minutes at high idle. (When doing this , leave the ra diator ca 11. Stop the engine. Ab out 3 minutes late r, supply the coolant up to the coolant filter, the 12. Open dr ain valve (5) and drain the wa ter from sub tank (6). 13. Flush th e inside of su b tank (6) with ta p water, then close dra valve (5) . 14.
Add wat er to sub tan k (6) until the coo lant level is b etween t FULL an d LOW mar