. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 15. Remove retader drain plug (9) and drain the oil from brake chamber. NOTICE Drain the oil from the brake chamber on both the left and right sides. H and L marks on sight gauge (G). Make sure that the oil level in the brake oil tank does not go stop the engine and raise the oil level in the brake oil tank. 4 - 76 16. After completely drainingthe oil fr om the brake chamber, install plug (8) and reterder drain plug ( NOTI Do n ot start up the engine without the tra nsmission being filled with oil. If the e ngine is started up while the transmi ssion is empty or short of oil, the transmission hydraulic pump will suffer d 17.
Before starting the engine, add 1 70 liters (44.91 US gal) of oil t l hrough oil filler port (F). When oil is added, the level will evel on sight gauge (G), but abnormality. 18. 19. Start the engine and run at low id Add oil through oil filler port (F) un down below the mark in the sight gauge (H) while the engine is unning at low idling. If the oil leve l goes down below (H) mark,