Komatsu — EVERY 4000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN STEERING, HOIST OIL TANK WARNING 4 - 87 EVERY 4000 HOURS SE Maintenance for every 250, 50 0, 1000 and 2000 hours service should be carried out at the s Immediately after the engine is s topped, the parts and oil are at high temperature, and there is danger th at this may cause burns during the operation. Wait for th e temperature to go down before s tarting the operation. When loosening the oil filler cap , do not loosen it suddenly. Loosen it gradually. The inside of the case is under high pressure, so if the oil filler cap is loosene d suddenly, oil may spurt out and c ause Refill capacity: 122 liters (32 1. Lower the dump body.

Stop the engine. Turn the cap of oil filler (F) slowly to release the internal cap. en loosen drain plug (2) slowly to f, and drain the oil. rain plug (1) and (2). nt of engine oil from oil filler (F). 2. 3. pressure, then remove the 4. Remove drain plug (1), th avoid getting oil on yoursel 5. After draining, tighten the d 6. Pour in the specified amou nt of engine oil from oil filler (F) 7. After adding oil, check that the oil is at the specified level. See CHECK OIL LEVEL IN ST ADD OIL (PAGE 3-71). EERING AND HOIST OIL TANK, LUBRICATE DRIVE SHAFT Carry out greasing every 4000 hours or every two years (whichever 1. Stop the engine. Using a grease pump, pu mp in grease through the grease ws.

2. fittings marked by the arro 3. Grease the spider portion u ntil grease comes out from the cap seal. 4. For the slide portion, contin ue greasing until grease comes out from vent. old grease that was pushed out. 5. After greasing, wipe off any old grease that was pushed o