Komatsu — CONTENT OF DISPLAY (CONTROLLER, EXTERNAL DISPLAY LAMPS)

. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) NOTICE see "WHEN ERROR CODE F-09 IS DISPLAYED partly inaccurate. 6 - 47 If the operation is not carri ed out properly, the payload will not b e measured c orrectly, so t he payload meter dat a or externa l lamp display will not be correct .

When the machine is unloaded, wh en it is stopp ed for loadin g, or when i t is stop ped when l oaded, always place the gear shift In the following cases (1 ) to (4), the condition of the dum p truck as s een by the p ayload meter will be differen t from the actual condition of t (1)When a new controll er has been installed has been replaced tery has been replaced f the following conditions should occur lamps give the estimate display although no loading is taking place.

(2)When the controller (3)When the built-in bat (4)In addition, if either o f the following conditions should o The external display lamps give the estimate display although no loading is t aking plac o The display gives th e time display when loading even if more tha n 50% of th e maximum payloa d is loade d and the machine starts t o travel. (The distance display is not given w hen travelin g 0 to 160 m. (0 to 524 ft 11 in)) In the case of (1), carry out calibration. For details, see " CARRYING OUT CALI BRATION (PAGE In the case of (2), carry o ut calibration. For details, see "O PERATION WHEN ERR OR CODE F.CAL IS DISPLAYED OR CONTROLLER HA S BEEN REPLACED (PAGE 6-8 7)".

In the case of (3), c arry out calibration. For detail (PROCEDURE FOR R EPLACING BATTERY) (PAGE 6 In the case of (4), carry out calibration. For details, see " CARRYING OUT CALI BRATION (PAGE recognize the empty (stopped) c ondition. Th e cycle data recorded when d umping m ay be After starting dumpi ng (operating the dump lever fro m FLOAT to RAISE), d o not turn t he pow er OFF within 5 5 seconds after compl eting the dumping (operating the dump lever from LOW ER to FLOAT). Also, with operations other than dumping, do not turn the power O FF within 5 seconds a fter ope rating the dump lever to FLOAT from any position other than FLOAT.

If the starting switch has been left at the ON position (p ower ON) fo r a long peri od without starting the engin e, first turn the starting swit If the engine is starte was at the ON positi the "Stopped,Loade ch to the OFF position, then start the engine . d without turning the starting swit ch first to the OFF positi on, the tim e that th e starting switch on without starting the engine will also be cal culated as p art of the " Stopped,Empty" ti me or d" time.