MAN — Man EPA07 MBE 4000 Engine Operator's Manual

HOW-TO SECTION 3. Using a 36-mm socket, unscrew the cap on the main fuel filter housing. Remove the cap and lift the filter element a short distance within the filter housing allowing the fuel to drain off the filter. 8. Fill fuel filter housing with clean fuel oil. 9. Install a new O-ring on the filter cap and screw the cap onto the filter housing. Tighten the cap to 25 N·m (18 lb·ft). 4. Remove the filter element from the cap and clean the filter cap. Discard the filter element and the O-ring from the cap. 10. Prime the fuel system by working the hand pump until resistance is felt. NOTE: There should be a strong resistance in the hand pump, caused by the pressure build-up within the fuel system.

NOTICE: To prevent damage to the filter housing, do not allow dirt to get into the filter housing. 11. Crank the engine for 30 seconds at a time, but no longer. Before cranking again, wait at least two minutes, then crank again. The engine should start within four 30-second attempts. 5. Clean the filter housing cap. 6. Replace the O-ring. 7. Lubricate the rubber seal, on the bottom of the filter element with a light coat of fuel oil and insert it into the filter housing. Push down and rotate the filter element while installing to ensure it is seated properly at the base of the housing. 12.

Once the engine starts allow it to idle for at least one minute or until idle is smooth before applying the throttle. Check the fuel filter housing for leaks. NOTE: A properly seated filter element will hold the fuel in the filter housing and prevent it from draining back to the tank. If the fuel does not stay in the housing the element is not seated properly, repeat steps 1 and 2. 90 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION