MAN — Man EPA07 MBE 4000 Engine Operator's Manual

OPERATING INSTRUCTIONS FOR STARTING THE ENGINE OPERATING INSTRUCTIONS FOR STARTING THE ENGINE Following are instructions for starting the engine. the engine overheats, uses excessive fuel or lubricating oil, vibrates, misfires, makes unusual noises, or shows an unusual loss of power, turn the engine off as soon as possible and determine the cause of the problem. Engine damage may be avoided by a quick response to early indications of problems. First Time Start Preparation When preparing to start a new or newly overhauled engine which has been in storage, perform all of the operations listed below. Also refer to the “ENGINE STORAGE” section of this guide.

Failure to follow these instructions may result in serious engine damage. When starting the engine in cold weather, refer to “How to Select Coolant” in the “HOW-TO SECTION” of this guide. Be sure you are familiar with all of the instruments, gauges and controls which are needed to operate the engine. System Checks Perform the following system checks before starting for the first time. Note especially the location and function of the following: Cooling System Checks Oil pressure gauge Check the cooling system as follows: Low oil pressure warning light 1. Make sure all drain cocks in the cooling system are installed (drain cocks are often removed for shipping) and are closed tightly.

Coolant temperature gauge High coolant temperature warning light Water in fuel warning light 2. Remove the radiator pressure control cap and fill with genuine Detroit Diesel POWER COOL ® antifreeze or an equivalent quality ethylene glycol (EG) or propylene glycol (PG) base antifreeze solution in the required Tachometer Air restriction indicator Watch for any signs of engine problems when starting or driving. If 18 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION