OPERATING INSTRUCTIONS FOR STARTING THE ENGINE [b] Check the oil feed and return lines at the turbocharger for tightness. Shut down the engine and tighten them if necessary. the radiator outlet pipe are secure and tight. 2. Check the coolant level. The cooling system is correctly filled when the coolant is between the maximum and minimum marks on the surge tank. 4. Shut down the engine. 5. Approximately five minutes after shutdown, check the engine oil level. If necessary, add oil up to the maximum fill level on the oil dipstick.(See Figure 13). Do not overfill. NOTE: For more information, Refer to the “Maintenance” section.
Checking the Coolant Level (Hot Check) Check the coolant levels as follows: 1. Allow the engine to run for approximately five minutes at a moderate speed. Figure 13 Oil Dipstick 6. Check all the mounting fasteners on the engine for tightness. Checking the Coolant Level (Cold Check) Check coolant level as follows: 1. Ensure that all coolant plugs in the bottom of the radiator and on 30 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION