OPERATING INSTRUCTIONS FOR STARTING THE ENGINE 3. Do a load test on the batteries. Charge or replace the batteries as needed. 1. Turn the cruise control switch to the OFF position. 2. To increase the idle speed, push the "Resume" switch until the idle is fast enough. 4. If necessary, visit the nearest authorized dealer to have the alternator voltage and output checked. 3. To decrease the idle speed, push the "Decel" switch until the idle is slow enough. Oil Pressure When the engine has reached its normal operating temperature, the engine oil pressure must not drop below the following values:
Shutting Down the Engine If the engine has been running at full output or the coolant temperature has been high, allow the engine to idle for one or two minutes without load. Then turn off the ignition key switch. 250 kPa (36 psi) at rated speed 50 kPa (7 psi) at idling speed If oil pressure drops below these values, stop the engine and determine the cause. If any of the following occur, shut down the engine immediately. The oil pressure swings back and forth or falls sharply. Excessive Idling Engine power and rpm fall, even though the accelerator pedal remains steady. Never allow the engine to idle for more than 30 minutes. Excessive idling can cause oil to leak from the turbocharger.
The exhaust pipe gives off heavy smoke. The coolant and/or oil temperature climb abnormally. Changing the Idle Speed The rpm range of the MBE 4000 engine is 600 to 850 rpm if the parameters in the Common Powertrain Controller (CPC) are set to the default range. Abnormal sounds suddenly occur in the engine or turbocharger. Change the idle speed as follows: 32 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION