EPA07 MBE 4000 OPERATOR'S MANUAL DDEC VI ENGINE DRIVING TIPS Cruise Control Driving with an electronically controlled engine feels different from driving with a mechanically governed engine. For added driver convenience and comfort, DDEC VI also features a Cruise Control option that works just like the system in your car. It can be operated in any gear above 1000 rpm or road speed faster than 32 kph (20 mph), up to the rated engine speed. And it can be programmed to hold your road speed at or below the maximum vehicle speed. The switch to energize Cruise Control is usually mounted on the instrument panel. See Figure 21.
Accelerating the Vehicle Engine response versus pedal movement may feel different from the mechanical-governed engine you were driving. The Accelerator Pedal (AP) was designed to communicate “percentage” foot pedal travel to the engine's Motor Control Module (MCM). The engine will respond accordingly to the driver's demand. Another throttle or governor characteristic you may need time to get used to is the DDEC Limiting Speed Governor. This allows the driver to command total engine response between idle and rated speed, such as accelerating at half throttle – an advantage when driving under slippery conditions.
If you require wide-open throttle engine response, either accelerating or just plain pulling hard, the throttle AP will have to be held to the floor. To obtain 100% fueling at any speed, the AP will have to be maintained at the fully pressed position. Figure 21 Typical Cruise Control Switches All information subject to change without notice. 47 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION