MAN — Man EPA07 MBE 4000 Engine Operator's Manual

EPA07 MBE 4000 OPERATOR'S MANUAL ENGINE SYSTEMS Air System The engine systems are the following: The outside air drawn into the engine passes through the air filter and is pulled into the turbocharger and compressed. It then moves to the air-to-air charge cooler (heat exchanger) and is cooled. Next it flows to the intake manifold and into the cylinders, where it mixes with atomized fuel from the injectors.

Fuel System The fuel system consists of DDEC, fuel injectors, fuel manifolds (integral with the cylinder head), Electronic Unit Pumps (EUP), fuel pump, a cooling plate for the Motor Control Module (MCM) on non-automotive engines, primary and secondary fuel filters, and the necessary connecting fuel lines. For optimum protection of the engine from dust and other airborne contaminants, service the dry type air cleaners used when the maximum allowable air restriction has been reached, or annually, whichever occurs first. The gear-type fuel pump is located near the front of the crankcase on the left hand side. The pump is driven from the forward end of the camshaft.

Lubrication System Cooling System The lubricating oil system consists of an oil pump, oil cooler, full-flow oil filter, bypass at the oil filter housing stand pipe, oil level dipstick and an oil pressure regulator at the oil pump. A radiator/thermo-modulated fan cooling system is used on MBE 4000 engines. This system has a centrifugal type fresh water pump to circulate coolant within the engine. Two full-blocking type thermostats located in a housing attached to the right side of the cylinder head control the flow of coolant. There is a force-feed lubricating oil circuit supplied by a gear-type oil pump. This pump is positioned at the rear of the oil pan and driven by gears from the crankshaft.

The oil cooler is integrated with the oil filter housing on the right-hand side. All information subject to change without notice. 57 DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION