MAN — Man EPA07 MBE 4000 Engine Operator's Manual

MAINTENANCE Uneven belt wear can indicate a loose, wore out, or bad bearing on the auto tensioner. A build up of dirt or grime around the front bearing surface of the wheel can indicate a future bearing failure due to inadequate lubrication. PERSONAL INJURY To avoid injury from rotating belts and fans, do not remove and discard safety guards. Belt Replacement – Drive belts (V and poly-V) should be replaced every 2,000 hours or 100,000 miles (160,000 km). Item 5 – Fuel/Water Separator If the vehicle is equipped with a fuel/water separator located on the frame rail, follow the manufactures recommendation on draining the trapped water and priming the fuel system.

Refer to section “Fuel/Water Separator Prefilter Element Cleaning” or refer to section “Replace Davco 382 Fuel Pro®Fuel/Water Separator Element” in this guide. After an extended time in service, minor rib cracks may appear, usually one or two cracks per inch is considered normal. See Figure 27. A concern occurs when the belt ribs exhibit severe multiple cracking or “chunking”. At this point, the belt should be replaced. Item 6 Fuel Filters The engine uses a cartridge style fuel filter. If followed correctly, a fuel filter change can be performed quickly with minimal cleanup. Refer to section “How to Replace the Fuel Filters” in this guide.

Figure 27 Minor Rib Cracking Auto Tensioner Auto tensioners are usually maintenance free for the life of the engine. However, routine inspections should be performed. 76 All information subject to change without notice. DDC-SVC-MAN-0041 Copyright © 2009 DETROIT DIESEL CORPORATION