Komatsu — 3.5.2 CAB

GUARDS, CAB AND DRIVER’S SEAT 3.5.2 CAB When opening or closing the door, pay attention not to hit persons staying around the door. When leaving the machine or moving so far that it cannot be seen any more, lock the door. 4 The cab is provided with a single door (1) that is used by the oper- ator to get on and off the machine. The door comprises two parts that can be opened independently of each other and that can be opened completely and secured in this position. 8 3 5 7 The upper part (2) of the door is used to ensure the circulation of fresh air. To open and fix it, pull the handle (3) and open the upper part (2) completely, until engaging the pin (4) in the safety retainer (5).

To close it, pull the knob (6) to release the pin (4) from the re- tainer (5), then close the window until engaging the pin (7) in the lock (8). RKAA1300 To open the entire door completely and lock it, the upper part must be closed; then pull the handle (9) and open the door until the pin (4) engages in the retainer (5). To close the door, release the pin by pushing or pulling the knob (6). 6 RKAA1210 4 5 6 9 RKAA1260 119 DANGER • If, for any reason, the cab is subjected to an impact, or if the machine overturns, immediately contact your Komatsu Utility Dealer, which will verify the stiffness of the cab and make sure that the operator’s safety is guaranteed.

• When working or travelling at low speed, keep the lower part of the door closed, in order to be protected from for- eign materials that may get into the cab. • When travelling at high speed, it is necessary to close the door and also the upper window. 2 1 RKAA1250 DANGER