Komatsu — 3.13.1 PREPARING THE MACHINE FOR A LONG PERIOD OF INACTIVITY

LONG PERIODS OF INACTIVITY 3.13 LONG PERIODS OF INACTIVITY 3.13.1 PREPARING THE MACHINE FOR A LONG PERIOD OF INACTIVITY When draining the fuel, do not smoke, nor use naked flames near the machine. Position a container under the machine to collect the fuel and avoid spilling it or pouring it on the tyres. If some fuel should be spilled, clean the dirty area immediately. NOTE These operations are to be carried out if the machine is going to remain unused for 1 month; if the peri- od of inactivity should be longer, perform also the operations indicated in «3.13.2 PREPARING THE EN- GINE FOR A LONG PERIOD OF INACTIVITY».

If the machine is going to remain unused for a long period, to keep its components in good conditions it is advisa- ble to store it in a sheltered place and to take the following measures: 1 - Clean the inside and the outside of the machine completely and very carefully, retouching any scratch on the paintwork in order to avoid oxidation. 2 - Drain and change all the fluids of the hydraulic circuits and the lubricants (axles, reduction gears, converter), following the indications given in the maintenance instructions. 3 - Change all the filtering elements (air filter, engine oil filter, hydraulic circuit filters, fuel filter).

4 - To prevent the deformation of the tyre sidewalls, insert supports or blocks under the axles, to nullify the weight of the machine. 5 - Grease the exposed rods of the hydraulic cylinders and the equipment and boom joints. 6 - Shift the machine controls to neutral and apply the parking brake. 7 - Seal the end of the exhaust pipe, the intake filter and the breather outlets of engine and hydraulic oil tank. 8 - Refuel completely. 9 - Remove the battery, check the electrolyte level and make sure that the battery is charged. Place the battery in a room with suitable temperature and recharge it periodically. 10 - Lock the cab door, the filler cap and the engine hood. 11 - Seal the filler cap.

156 DANGER