OPERATIONS IN CASE OF FAILURE 3.14.5.5 ENGINE 165 TROUBLE CAUSE REMEDY Oil pressure warning light remains on even with engine at high speed: • Oil level in oil pan too low. • Oil filter clogged. • Oil unsuitable for the season. • Top up. • Change filter. • Change. Steam comes out of radiator breather pipe: • Fluid level low, fluid leakages. • Fan belt slack. • Radiator fins damaged or closed. • Faulty thermostat. • Radiator cap loose or broken. Working at considerable altitude. • Top up, repair. • Check belt tension. • Repair or clean. (•) Change. • Tighten cap or change unit. Temperature indicator always on the right end of the scale: • Faulty temperature indicator.
(•) Change Temperature indicator pointer always on the left end of the scale: • Faulty thermostat. • Faulty indicator. (•) Change. (•) Change. Engine does not start: • Battery down. • Battery terminals loose or corroded. • No fuel. • Type of fuel unsuitable for climate. • Air in fuel supply circuit. • Other causes. (•) Charge or replace. (•) Tighten nuts or change terminals. • Refuel. (•) Change filter. Refuel with winter type. (•) Check pipes, connections, fuel and injection pumps. Bleed the circuit. (•) Contact Dealer. Engine stops: • Fuel filters clogged. • Air in fuel supply circuit. • Other causes. (•) Change. (•) Check pipes, connections, fuel and injection pumps. Bleed the circuit.
(•) Contact Dealer. Engine overheats: • Radiator clogged. • Insufficient tension of water pump and fan belt. • Low coolant. • Air filters clogged. • Clean fins. (•) Check and adjust belt tension. • Top up. (•) Clean or change filters. Engine power insufficient: • Impurities or water in fuel supply circuit. • Fuel filter clogged. • Air filter clogged. (•) Clean and refuel with new fuel. (•) Change. (•) Clean or change filters. Exhaust gases white or light blue: • Too much oil in oil pan. • Unsuitable fuel. • Other causes. • Restore correct level. • Change with fuel in compliance with standards. (•) Contact Dealer. Exhaust gases occasionally tend to be black: • Air filter clogged.
• Faulty injectors. • Clean or change. (•) Change. Combustion noise occasionally resem- bles a blow: • Faulty injectors. (•) Change. Abnormal noises (during combustion or in mechanical parts): • Fuel with low cetane rating. • Overheating. • Exhaust silencer inside damaged. • Excessive valve clearance. • Change with fuel in compliance with standards. • See “defects of temperature indica- tor”. (•) Change. (•) Adjust valve clearance.