GUIDE TO MAINTENANCE 4.1 GUIDE TO MAINTENANCE Before opening the engine hood and if it is necessary to check the hydraulic oil level in the tank, position the ma- chine as if it were going to be parked (boom completely retracted and lowered). Carry out any operation on firm and level ground, after applying the parking brake. Use Komatsu Utility genuine oils and greases; choose oils suitable for the ambient temperature. Use clean oils and greases. Keep the oil and grease containers clean and prevent any foreign matter from get- ting into them. Always keep the machine clean: this makes it easier to locate any failed part.
In particular, keep the grease nipples, the breathers and the areas near the openings for the level checks clean and prevent any impurities from getting into/on them. Draining hot oil or coolant immediately after stopping the engine is hazardous; let the engine cool down until reaching a safe temperature of 40–45°C. After changing the oil or the filters, check if there are metal particles. If you find large quantities of metal particles, contact your Komatsu Utility Dealer. Check and change the oil in a clean place and prevent any impurities from getting into the tank.
Before carrying out any maintenance operation, hang a warning plate on the ignition switch, the control levers and the cab doors, to prevent anyone from starting the engine. When performing maintenance operations, always take the precautions indicated on the safety plates applied to the machine. Instructions for arc welding: 1 - Turn the ignition key to position « O ». 2 - Disconnect the battery (first the negative pole and then the positive pole). 3 - Disconnect the alternator. 4 - Disconnect the gearshift-reverse unit connector positioned under the steering wheel. 5 - Do not apply more than 200V continuously.
6 - Connect the earth cable within 1 m from the point where the welding operation must be carried out. 7 - Avoid placing gaskets and bearings between the welding area and the earth cable. Do not use flammable fluids to clean any parts of the machine. Keep naked flames away from these fluids and avoid smoking. When O-rings and gaskets are removed, clean the sealing surfaces thoroughly and replace the O-rings and gas- kets with new ones. Fit the O-rings and gaskets correctly when reassembling. Avoid keeping loose objects or tools in your pockets: they may fall out and drop into the machine, especially when you open covers and work on the machine while bending over it.
When washing the machine, do not direct the high-pressure water jet onto the radiator and the heat exchanger. When washing the machine, protect the electric system connectors and avoid wetting the ignition switch and en- gine central unit. Before starting work in mud, under the rain, on seashores or river banks, provide for lubrication where required. Wash the machine immediately after work in order to protect its components from oxidation. Lubricate the equipment joints more frequently than usual. When the worksite is particularly dusty, proceed as follows: 1 - Check the engine air cleaner and the cab air filter for any clogging and clean them more frequently than pre- scribed.
2 - Clean the radiator and the heat exchanger frequently, to avoid any clogging of the fins. 3 - Change the diesel oil filter more frequently than usual. 4 - Clean the electrical components, especially the starter and the alternator, to avoid any accumulation of dust. Never mix oils of different brands. Do not top up with any oil different from that used in the machine. If necessary, drain the tanks and fill them with the oil of the new brand. 168