PERIODICAL CHANGE OF THE SAFETY-RELATED COMPONENTS 4.6 PERIODICAL CHANGE OF THE SAFETY-RELATED COMPO- NENTS NOTE It is advisable to consult the Komatsu Utility Dealer to define the periodical replacement of the specified components, which should be performed on the fourth maintenance service to be carried out every 1000 hours of operation or before the first maintenance service to be carried out «EVERY 2 YEARS». To ensure safety at any moment while driving and using the machine, the operator must carry out all the routine maintenance operations prescribed.
Moreover, to increase safety even further, the operator must provide for the periodical change of the components indicated in the tables on the following pages, which are especially related to safety and fire-prevention rules. These components are subject to wear and tend to deteriorate over time. Since it is particularly difficult to evaluate their conditions through simple routine maintenance, after a certain period it is advisable to change them inde- pendently of their state, in order to keep the machine efficient over time. Repair or replace these components immediately in case of failures or anomalies, even if the time interval pre- scribed for their change has not elapsed yet.
If the pipe clamps show signs of deterioration, like deformations or cracks, provide for changing them together with the pipes. In addition to the periodical change of the components listed on the following pages, it is necessary to in- spect the hydraulic pipes by proceeding as described here below. In case of anomalies, carry out all the necessary repairs and changes, or adopt any other measure required. 180 Type of check Items to be checked Before starting the engine Leakages from joints, hydraulic pipes or fuel pipes. Periodically (monthly) Leakages from joints, hydraulic pipes or fuel pipes. Damaged hydraulic or fuel pipes (cracks, wear and tear).
Periodically (yearly) Leakages from joints, hydraulic pipes or fuel pipes. Deteriorated, twisted, damaged hydraulic or fuel pipes (cracks, wear and tear) or pipes in contact with other parts of the machine.