Komatsu — 2.3.3 PRECAUTIONS CONCERNING THE DRIVING POSITION

PRECAUTIONS TO BE TAKEN BEFORE STARTING WORK 2.3 PRECAUTIONS TO BE TAKEN BEFORE STARTING WORK 2.3.1 SAFETY ON THE WORKSITE Before starting a new work, carefully check if there are holes, depressions, obstacles, yielding areas, deep mud, still water, wet points or slippery surfaces, and to do this ask the help of the supervisor or the site coordinator. If one or more of the problems listed above can be observed, it is necessary to level the ground, reclaim the yielding areas and remove the objects that may cause tyre punctures. Check the conditions of the ground at the work site and before starting the engine define the work plan and the best and safest operating procedure.

In case of work on roads, protect pedestrians and cars by des- ignating a person for work site traffic duty and install fences around the work site. Proceed very slowly when getting near crossroads. Avoid crossing overhead rails, grooves, pavements, traffic divid- ers or ditches. If these obstacles cannot be avoided, be very careful and lower the speed as much as possible. If it is necessary to cross rivers, check the depth of the water and the force and direction of the current.

RKA02340 2.3.2 FIRE PREVENTION Completely remove all wood chips, rubbish, paper and other flammable materials that may have accumulated inside the en- gine compartment and on the radiator, since they can cause fires. Check the fuel and hydraulic system pipes for leaks and if nec- essary repair them. Wipe up any excess oil, fuel or other flammable fluids. Make sure that fire extinguishers are available in the work area. RKA00430 2.3.3 PRECAUTIONS CONCERNING THE DRIVING POSITION Do not keep objects or tools in the operator's cab. They may hinder the application of the brakes and cause seri- ous accidents.

Keep the cab floor and the controls (pedals, steering wheel and levers) clean, by removing any trace of oil and grease and, as far as the floor is concerned, remove any excess dirt (earth, stones, etc.). Check the safety belt and change it if it is broken or damaged. Replace any component only with homologated parts available at Komatsu Utility or its Dealers. 39