PRECAUTIONS TO BE TAKEN DURING MAINTENANCE 2.8.15 PRECAUTIONS CONCERNING HIGH-PRESSURE HOSES AND FUEL PIPES Do not bend high-pressure hoses or rub them with sharp or abrasive objects. Do not use bent or cracked pipes or hoses that were previously rejected because of leaks or fastening defects, since they may burst during use. Always repair or replace any loose or faulty fuel or oil pipe. Any leakage of fuel or oil may cause fires. 2.8.16 PRECAUTIONS TO BE TAKEN WHEN WORKING ON HIGH- PRESSURE SYSTEMS DANGER!
Do not forget that the work equipment circuits are always under pressure; for this reason, when it is necessary to add or drain hydraulic oil, or to service or inspect the hydraulic circuit, it is advisable to lower the equipment to the ground and completely release the pressures and the residual pressure present in the tank. Small leakages from pipes under pressure and the resulting jets are extremely dangerous, since they can perforate the skin and penetrate in the blood circulation or injure the eyes. For this reason, always wear goggles and thick gloves during the inspections and use a piece of cardboard or a sheet of ply- wood to check for oil leakages.
If you are struck by a jet of high-pressure oil or are injured, even if slightly, consult a doctor without delay. CORRECT 2.8.17 PRECAUTIONS FOR MAINTENANCE WORK INVOLVING HIGH TEMPERA- TURES AND PRESSURES When the machine is stopped at the end of operations, the en- gine coolant, the oil and all the components are hot and the hy- dralic circuits are under pressure. In these conditions, if the coolant, the hydraulic oil and the en- gine oil are to be drained in order to change them or the filters, there are serious risks of damage and burns.
Wait for the temperature to lower within the normal operating range (42°C) before carrying out the maintenance operations in accordance with the procedures indicated in the relevant sec- tions of this manual. RKA00230 61