Komatsu — ADJUST IDLER CLEARANCE

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING equipment lock lever. Tightening torque: 1499 ± 157 Nm (153 ± 16 kgm , 1106.6 ± 115.7 lbft) 6. After several hours of running, retourque the nuts. REMARK The tightening operation is easier if the power wrench that has been supplied is used. 4 - 33 It is dangerous if the work eq uipment moves by mistake when the cutting edges and end bits are being reversed or replac with work Reverse or replace the en d bits and cutting edges before i t is wor n out to the blade end roper height, position a block un der the frame to prevent the blade from falling. ipment lock lever to the LOCK p osition.

the end bit on both sides are w orn out, replace with new one e is worn, correct it before turnin move bolt (2). Then remove the cutting nd clean the mounting surface. cutting edge and the end bit whe n worn e damaged, replace them with ne w ones blade, then tighten partially. Drop the s on to the ground or rock to remo ve any ghten it to the correct tightening torque. t (3), put top surface (4) of the en d bit in pper (5), then tighten with the bo When the nut is rusted an d is removed by gas cutting, cut on both side (6) of the nut as show n in the diagram. seat surface (7). . Be careful not to get spatter on the Be careful not to damage If it is damaged, repair it mounting surface.