Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE (including engine by-pass filter cartridge) WARNING bottom left at the front of the and put a container directly loosen drain valve (2) slowly to valve (2) so much that the ± 9.81 Nm (7 ± 1 kgm, 50.6 ± 7.2 lbft) ± 14.7 Nm (6.5 ± 1. 5 kgm, 47.0 ± 10.8 lbft) is excessive metal particles or bring the packing surface add engine oil through oil 4 - 55 EVERY 500 HOURS SERVIC Maintenance for every 250 hours should be performed at the sam The oil is at high temperature after the engine has been operated, so never change the oil immediately a fter finishing operations.

Wait for the oil to cool down before ch anging it. Refill capacity: 50 liters (13.2 U Prepare a socket wrench and fil 1. Remove the covers at the b machine and on the side fac underneath to catch the draine 2. Remove drain plug (1) and lo avoid getting oil on yourself, a Take care not to loosen drai stopper pin in the valve is disto Tightening torque for drain plu Tightening torque for drain val 3. Check the drained oil, if there avoid getting oil on yourself, a Take care not to loosen drai stopper pin in the valve is disto Tightening torque for drain plu 3. foreign material, contact your 4. Tighten drain valve (2), then ti 5. Using the filter wrench, turn en left and remove it. 6.

Clean the filter holder, fill the ne coat the packing surface and t thinly with grease), then install 7. When installing the filter cartri into contact with the filter holde 8. turn. After replacing the filter cartri filler port (F) until the oil level is the dipstick.