50 Disassembly and assembly SEN00949-00 a When installing floating seals, thoroughly clean, degrease, and dry the contact sur- faces of the O-rings and floating seals (hatched parts). Take care that dirt will not stick to the floating seal contact surfaces. a After installing the floating seals, check that their slant is less than 1 mm and their projection (a) is 7 – 11 mm. 8. Using tool L1 , install floating seal (7) to idler (3). a For the method of installation, see step 4. 9. Using tool L1 , install floating seal (5) to support (4). a For the method of installation, see step 4. 5. Fit the O-ring to the shaft. 6. Using tool L1 , install floating seal (8) to idler (3).
a For the method of installation, see step 4. 10. Drive in bolt (2) and tighten nut (1). 7. Sling and install idler (3) to shaft and support assembly (6). a Prevent the sling wires from opening with wires or ropes. D65EX, PX, WX-15E0 7