Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — DISASSEMBLY AND ASSEMBLY OF RECOIL SPRING ASSEMBLY

SEN00949-00 50 Disassembly and assembly Assembly 3. Install nut (16), then install spacer (17). 1. Press fit bushing (20) to cylinder (19), and assemble case (12), spring (18), and cylinder (19) temporarily, then set to tool M . k The spring is under a high installed load, so be careful to set all parts cor- rectly. 4. Gradually release hydraulic pressure to com- pletely remove tension of spring, then remove recoil spring assembly (1) from tool M . 5. Assembly of holder Assemble seal (15) to holder (13), then install cover (14). 2 Lip of seal: Grease (G2-LI) 6. Install holder (13) to case (12) of recoil spring. 2.

Apply hydraulic pressure slowly to compress spring, and set so that installed length of the spring is the standard value. a When compressing the spring, be careful not to damage the thread. Use lever block [2] and carry out centering while com- pressing the spring. a Installed length of spring: 634 mm 12 D65EX, PX, WX-15E0