50 Disassembly and assembly SEN00952-00 8. Start the engine and move the machine in reverse slowly to disconnect blade assembly (7) from trunnion (8). [*3] [*3] a Adjust height (b) and width (c) of both straight frames to the following values with block [2], etc. q Trunnion height (b): D65EX: 422 mm D65PX: 529.4 mm q Frame width (c): D65EX: 2,352 mm D65PX: 2,888 mm Installation q Carry out installation in the reverse order to removal. [*1] a Adjust clearance (a) at the mating face of the cap to the following value with shims and check that the shims rotate smoothly. q Standard shim thickness: 5 mm a After installing the blade, adjust its tilting dis- tance.
For details, see Testing and adjusting, “Adjusting blade”. q Standard clearance (a): 0.2 – 0.5 mm q Refilling with oil (Hydraulic tank) Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then, check the oil level again. q Bleeding air Bleed air from the work equipment cylinders. For details, see Testing and adjusting, “Bleed- ing air from work equipment cylinders”. [*2] a Adjust the shims of the trunnion. For details, see Testing and adjusting, “Adjusting blade”. D65EX, PX, WX-15E0 3