Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — CONTROL VALVE

10 Structure, function and maintenance standard SEN00286-01 Function q It consists of a parallel circuit, so when com- pound operations are carried out, the oil flow is divided according to the size of each spool opening. Operation q When tilt spool (1) and lift spool (2) are at the “hold“ position or are “operated“, steering prior- ity valve (3) is pushed completely to the right, and the size of the opening to the downstream area is at its maximum. q Tilt spool (1) and lift spool (2) are actuated by PPC valve output pressure (PA2) and (PB3), and each is balanced at a position that matches its own pilot pressure.

q Lift valve load pressure (P3) is sent to pump LS valve (4) through LS passage (O). When pressure (P2) Z (P3) 1) When pump swash plate does not reach maxi- mum angle q When the maximum flow of oil from the pump is greater than the total of the oil flow demanded by the tilt valve and lift valve, an oil flow that matches the opening of the spool flows to both the tilt valve and lift valve.

2) When pump swash plate is at maximum angle q When the maximum flow of oil from the pump is smaller than the total of the oil flow demanded by the tilt valve and lift valve, the flow of oil to the tilt valve and lift valve is divided according to differential pressure (PO) – (P2) and differential pressure (PO) – (P3). q In other words, more oil flows to (P2) where the load is small. a In cases where the blade is raised above ground and the tilt valve and lift valve for “raise“ are operated at the same time, the tilt valve load pressure is smaller than the lift valve load pressure, so the flow of oil to the tilt valve is given priority.

In addition, the oil flow demanded by the tilt valve is smaller, so the condition is just as if priority was given to the oil flow for the tilt valve. When pressure (P2) = (P3) q (P) – (P2) C (P) – (P3), so an oil flow propor- tional to the size of the spool opening is distrib- uted to each spool. D65EX, PX, WX-15E0 33