10 Structure, function and maintenance standard SEN00287-01 Outline q The quick drop valve is installed between con- trol valve and lift cylinder. When blade control lever is set in “lower“ position the quick drop valve prevents a vacuum on cylinder bottom side and shortens time lag in starting digging. q The blade lowering speed is mostly decided by the pump discharge. However, it can be heightened by installing the quick drop valve.
Operation Start of lowering blade While lowering blade q If the blade control lever is set in “lower“ posi- tion, oil from the control valve flows into port (VB) and further flows through ports (CB1) and (CB2) to the cylinder bottom and pushes the cylinder piston to the left. q The oil pushed out of cylinder head side flows through port (CH2) to port (VH). At this time, the oil flow rate is reduced by orifice (a) and pressure difference is made before and after the orifice. q The oil in the cylinder head side is pushed out by the cylinder piston into port (CH2), flows through port (VH) and control valve into the hydraulic tank.
q If oil pressure in port (CH2) rises higher than the tension of springs (1) and (2), valve (3) and piston (4) move to the right. q Since ports (VB) and (CH2) open, part of the oil which has been flowing from port (CH2) to port (VH) merges with the oil from control valve and flows into cylinder bottom side. q Accordingly, the blade lowering speed is increased by the quantity of oil flowing into cyl- inder bottom side and vacuum on the bottom side is prevented. D65EX, PX, WX-15E0 17