SEN00290-01 10 Structure, function and maintenance standard Preset mode function Auto shift-down function q The gear speed applied for forward travel and reverse travel can be set in advance. Preset mode 1: F1 – R1 Preset mode 2: F1 – R2 Preset mode 3: F2 – R1 Preset mode 4: F2 – R2 Preset mode 5: F2 – R3 q If the travel speed lowers because of the load- ing condition, the transmission gear is shifted down automatically.
1) The traction force (load on the chassis) is calculated from the engine speed, trans- mission output shaft speed, and the throt- tle information sent from the transmission and steering controller, and then the trans- mission gear is shifted down automatically according to the load and travel speed. 2) Once the transmission gear is shifted automatically, it is not shifted up again automatically. (It can be shifted up with the UP switch of the PCCS lever, however.) 3) This function is applicable to both forward and reverse travels. 1. How to use 1) Set the PCCS lever in the “N (Neutral)“ position. 2) Set preset mode switch (1) to the “ I (ON)“ position.
3) Press the UP/DOWN switch of the PCCS lever to select a mode. 1. How to use 1) Set automatic shift-down switch (2) to the I (ON)“ position. 2. Display q The selected mode is displayed on display panel B of the monitor panel. 24 D65EX, PX, WX-15E0