SEN00584-00 20 Standard value table 10 D65EX, PX, WX-15E0 Machine model D65EX,WX-15 Classification Check item Measurement conditions Unit Standard value for new machine Permissible value Work equipment Work equipment speed Blade lift aSee figure A • Hydraulic oil tem- perature: 45 – 55°C • Apply no load to blade. • Between ground level and rising end of blade • Engine: High idle Raise Second 2.6 (+0.2/ – 0.5) 3.1 Lower 1.7 ± 0.2 2.0 Blade tilt aSee figure B • Hydraulic oil tem- perature: 45 – 55°C • Apply no load to blade. • Between left tilt end and right tilt end • Engine:
High idle Left tilt Straight tilt 2.5 ± 0.3 3.0 Power tilt (If equipped) — — Right tilt Straight tilt 2.3 ± 0.3 2.8 Power tilt (If equipped) — — Ripper lift (If equipped) aSee figure C • Hydraulic oil tem- perature: 45 – 55°C • Apply no load to rip- per. • Between ground level and rising end of ripper. Raise Low idle 2.4 ± 0.2 2.9 High idle 1.4 ± 0.2 1.9 Lower Low idle 1.9 ± 0.2 2.4 High idle 1.1 ± 0.2 1.6 Pitch speed (If equipped) aSee figure D • Hydraulic oil tem- perature: 45 – 55°C • Apply no load to blade. • Pitch in – pitch back • Engine: High idle Pitch in — — Pitch back — — Time lag Blade • Hydraulic oil temperature: 45 – 55°C • Move lever to stroke end. • Lower blade from max.
rising position and measure time after blade comes in contact with ground until idler is lifted. • High idle Second Max. 1.3 Max. 1.6 Hydraulic drift Hydraulic drift of lifted blade aSee figure E • Hydraulic oil temperature: 45 – 55°C • Stop engine. • Measure reduction of blade bottom height h. mm/ 15min Max. 100 Max. 100 Hydraulic drift of tilted blade aSee figure F • Hydraulic oil temperature: 45 – 55°C • Stop engine. • Hydraulic drift of tip of blade cutting edge Left tilt Max. 200 Max. 200 Right tilt Max. 200 Max. 200 Hydraulic drift of lifted ripper aSee figure G • Hydraulic oil temperature: 45 – 55°C • Stop engine. • Measure reduction of shank bottom height h (for 15 minutes). Max.
50 Max. 50