Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — BLEEDING AIR FROM FUEL CIRCUIT

SEN00585-00 30 Testing and adjusting Bleeding air from fuel circuit 1 2. Fill up the fuel tank with fuel. a Bleed the air by electric lift pump as follows if the engine has run out of fuel or the fuel circuit equipment has been removed and installed. 3. Turn the starting switch ON. q The lift pump is operated for 30 seconds automatically. k Do not turn the starting switch to start position. 1. The installation procedures for fuel main filter (1) and fuel pre-filter (2) after their removal, installation or replacement are as follows. 4. Return the starting switch to OFF position, and keep it for 10 seconds. 5. Repeat the above 3 and 4 operation 4 times. 6.

Crank the engine with the starting motor and start the engine. a The air in the high-pressure circuit is bled automatically if the engine is cranked. a If the engine does not start, there may be still air in the low-pressure circuit. In this case, repeat the above procedure from step 2. a If the engine is run when there is still air in the fuel circuit, fuel circuit errors ( CA449 , CA559 ) may occur. In this case, start the engine after the procedure above, and continue to drive the engine for about 3 minutes at low idle. When air is bleed from fuel circuit, engine speed is stabilized and error display will disappear. 1) Do not fill fuel into fuel main filter (1).

2) Fill up fuel into fuel pre-filter (2). q When filling, use clean fuel and be careful not to let dirt get in. q Add fuel through inlet port ( a ) areas (8 places) of the filter. Area ( b ) is the outlet port (clean side) after the fuel has been filtered, so never add fuel from here. 3) Apply a thin coat of oil on the packing sur- face of the filter and install it to filter head until it touches the sealing surface, then tighten 3/4 rotation. (For the procedure to replace fuel filter cartridge, see the Opera- tion and Maintenance Manual.) 28 D65EX, PX, WX-15E0